Processing of Sibu Design Boards
1. Acclimatising of the materials
The design boards are used as a surface and a substrate. Before processing, all materials have to be left to acclimatise.
3. Sanding the reverse side
Sand the reverse sides of the design boards with a random orbital sander. Use a sanding paper size 80 grit.
4. Cleaning the back of the Sibu board
Thoroughly clean the reverse sides. After vacuuming, use a cleaning cloth as well to wipe the decor boards. For the substrate, the blow off is enough.
Apply the glue to the substrate with a toothed spatula. The applied quantity should be between 100 - 150 g / m², depending on the absorbency of the substrate.
6. Pressing of the boards
Place decor boards in the middle of the substrate and press with a pressure of 0.5 N / mm². At 20°C, the pressing time is approx. 30 minutes. The maximum pressing temperature is at 45°C.
Let the decor boards cool down for approx. 16 hours after pressing. If properly bonded, the workpiece can then immediately be milled and further processed.
Sibu Design Boards from OSTERMANN can be used as furniture surface, filling, wall covering or for display and trade fair stand construction.
