Dispersion adhesives

Dispersion glues are water-based liquid glues that solidify after the evaporation of water. The dispersion adhesives include, for example, all the white glues. These are used for bonding soft and hard woods, for HPL surface face bonding, for gluing board gaps, for block bonding and carcass and assembly applications. The addition of hardeners boosts the adhesive properties of white glues. OSTERMANN supplies glues and hardeners from various manufacturers to cover various applications.

Tip: REDOCOL adhesives are particularly good while being economical at the same time.

There several process steps that need to be considered in order to obtain a perfect result with dispersion glues. These are indicated on the corresponding technical data sheets. If the different steps are not properly executed, bonding defects may occur. One mistake often made is to exceed of the open time. If it is exceeded, for example, if the glue application on large workpieces takes too long, the bond between the two substrates will not be as strong. Another source of error is the minimum pressure time. Although it is indicated on the technical data sheet of the particular product, it is also influenced by the type of wood and the pressing temperature. A longer pressing time is needed e.g. for hard-textured wood as well as for resinous or oleaginous woods.

The open time indicated on technical data sheets is subject to standardised conditions according to DIN EN 16556. The required time is longer when the room temperature is low. With temperatures above 30 °C, the open time is significantly shorter. A 10 °C higher temperature reduces the open time by approximately one third. If the boards the adhesive is applied upon is too cold, there is a so-called chalk effect. The drying adhesive is getting crumbly, there are white spots and and there is no bonding effect.

Dispersion glues are classified under standardised conditions into 4 different groups, according to their water-resistance (D1 to D4). D1 is used for up to 15% wood moisture, D2 for up to 18%, D3 for short-time influence of humidity (e.g. for bathroom furniture) and D4 for frequent and longer influence of water (e.g. in swimming pools). The standard classifications in Europe are D2 to D4. For applications in exposed exterior areas, use dispersion adhesives classified as D4. Still, the additional use of an adequate surface coating is indispensable in order to protect the furniture.

Dispersion adhesives can change the colour of the wood. The reason for this is the acidity of the adhesives, which can lead to discolouration, especially with tannic woods. White glues classified as D1 or D2 are pH-neutral and do not cause discolouration. Classic D3 dispersion glues are in the acidic range, with a pH value of 2.5 to 3.5. Some wood types are particularly susceptible to discolouration. When processing, for example, cherry tree or maple, but also thin veneers, the acidic pH value can cause colour changes in the wood. If and how quickly a particular wood will discolour also depends both on the location and on the region of which the natural wood product originates. Another factor is the exposure of the finished workpiece to heat and UV radiation. Therefore, for approximately 10 years, there have been pH-neutral D3 glues with a pH value of 5.0 to 7.0.

If the acidic dispersion comes into contact with iron and is then applied onto the wood, there will occur a classic blue discolouration in the wood. Therefore, all components that come into contact with the adhesive should be made of stainless steel (V2A / V4A) or plastic. When using a drilling machine and a blender, the blender must not show any defects in the coating (no bare metal). Otherwise, discolourations might occur.